i386 fenv code checks __hwcap for sse support, but in fesetround the sse
code was unconditionally jumped over after the test so the sse rounding
mode was never set.
fesetround.c is a wrapper to do the arch independent argument
check (on archs where rounding mode is not stored in 2 bits
__fesetround still has to check its arguments)
on powerpc fe*except functions do not accept the extra invalid
flags of its fpscr register
the useless FENV_ACCESS pragma was removed from feupdateenv
the x87 exception summary (ES) and stack fault (SF) flags may be
spuriously cleared by feclearexcept using the fnclex instruction,
but these flags are not observable through libc hence maintaining
their state is not critical.
the sse and x87 rounding modes should be always the same,
the visible exception flags are the bitwise or of the two
fenv states (so it's enough to query the rounding mode or
raise exceptions on one fenv)
Note that the new fesetround has slightly different semantics:
Storing the floating-point environment with fnstenv makes the
next fldenv (or fldcw) "non-signaling", so unmasked and pending
exceptions does not invoke the exception handler.
(These are rare since exceptions are handled immediately and by
default all exceptions are masked anyway. But if one manually
unmasks an exception in the control word then either sets the
corresponding exception flag in the status word or the execution
of an exception raising floating-point operation gets interrupted
then it may happen).
So the old implementation did not trap in some rare cases
where the new implementation traps.
However POSIX does not specify anything like the x87 exception
handling traps and the fnstenv/fldenv pair is significantly slower
than the fnstcw/fldcw pair (new code is about 5x faster here and
it's dominated by the function call overhead).
at present the i386 code does not support sse floating point, which is
not part of the standard i386 abi. while it may be desirable to
support it later, doing so will reduce performance and require some
tricks to probe if sse support is present.
this first commit is i386-only, but it should be trivial to port the
asm to x86_64.
Szabolcs Nagy